Fenix TK25 – 1000 Lumens White / RED Beam Led Torch

Operations

Dual Switches
The round switch is the tactical switch and the oval switch the functional switch.
ON/OFF
Tap the tactical switch to momentarily turn on the light; the light will activate last memorized output on White light mode, or last memorized output on Red light mode; release and the light will go out.
Fully press the tactical switch to constantly turn on the light. Press again to turn off the light.
With the light switched off, press the functional switch for instant strobe activation on White light mode, or to enter Red high on Red light mode; release it and the light will go out.
Strobe
With the light switched on on White mode – long press the functional switch to activate strobe. Click once again to return to previous output.
Output Selection
With the light on on White mode – single click the functional switch to cycle through Low→Med→High→Turbo.
With the light on on Red mode – single click the functional switch to cycle through Low→Med →High.
Mode Switching
Rotate the light head to switch between white and red light modes.

Intelligent Memory Circuit
The light memorizes the last selected brightness level on White and Red light modes. When turned on again the previously used brightness level will be recalled.

Low-voltage Warning
When the voltage level drops below the preset level, the flashlight is programmed to downshift to a lower brightness level until Low output is reached. When this happens in Low output mode, the flashlight blinks three times every five minutes to remind you to replace the battery. To ensure normal use, the flashlight will not turn off automatically and will work till the battery runs out completely. (White light flashes on White light mode and Red flashes on Red light mode.)

Overheat Protection
The light will accumulate a lot of heat when used on Turbo output level for extended periods. When the light reaches a temperature of 65°C or above, the light will automatically step down by a few lumens to reduce temperature. When the temperature is reduced, the output will gradually return to Turbo output level.